firmware/bin/config-dist.yaml

### Define your devices here using Broadcom pin numbering
### Uncomment the block that corresponds to your hardware
---
Lora:
#  Module: sx1262  # Waveshare SX126X XXXM
#  DIO2_AS_RF_SWITCH: true
#  CS: 21
#  IRQ: 16
#  Busy: 20
#  Reset: 18

#  Module: sx1262  # Waveshare SX1302 LISTEN ONLY AT THIS TIME!
#  CS: 7
#  IRQ: 17
#  Reset: 22

#  Module: RF95  # Adafruit RFM9x
#  Reset: 25
#  CS: 7
#  IRQ: 22
#  Busy: 23

#  Module: RF95  # Elecrow Lora RFM95 IOT https://www.elecrow.com/lora-rfm95-iot-board-for-rpi.html
#  Reset: 22
#  CS: 7
#  IRQ: 25

#  Module: sx1280  # SX1280
#  CS: 21
#  IRQ: 16
#  Busy: 20
#  Reset: 18

### Set gpio chip to use in /dev/. Defaults to 0.
### Notably the Raspberry Pi 5 puts the GPIO header on gpiochip4
#  gpiochip: 4

### Define GPIO buttons here:

GPIO:
#  User: 6

### Define GPS

GPS:
#  SerialPath: /dev/ttyS0

### Set up SPI displays here. Note that I2C displays are generally auto-detected.

Display:

### Waveshare 2.8inch RPi LCD
#  Panel: ST7789
#  CS: 8
#  DC: 22        # Data/Command pin
#  Backlight: 18
#  Width: 240
#  Height: 320
#  Reset: 27
#  Rotate: true

Touchscreen:
#  Module: XPT2046
#  CS: 7
#  IRQ: 17

### Configure device for direct keyboard input

Input:
#  KeyboardDevice: /dev/input/event0