diff --git a/src/mesh/SX126xInterface.cpp b/src/mesh/SX126xInterface.cpp
index e5b9eada8..dfe2433e8 100644
--- a/src/mesh/SX126xInterface.cpp
+++ b/src/mesh/SX126xInterface.cpp
@@ -72,7 +72,8 @@ template <typename T> bool SX126xInterface<T>::init()
         res = lora.setDio2AsRfSwitch(false);
 #endif
 #ifdef SX126X_E22
-    // E22 Emulation explicitly requires DIO2 as RF switch, so set it to TRUE again for good measure. In case somebody defines SX126X_TX for an E22 Module
+    // E22 Emulation explicitly requires DIO2 as RF switch, so set it to TRUE again for good measure. In case somebody defines
+    // SX126X_TX for an E22 Module
     if (res == RADIOLIB_ERR_NONE)
         res = lora.setDio2AsRfSwitch(true);
 #endif
diff --git a/variants/rak4631/variant.h b/variants/rak4631/variant.h
index 0784e80ab..fe5540974 100644
--- a/variants/rak4631/variant.h
+++ b/variants/rak4631/variant.h
@@ -192,7 +192,8 @@ Important for successful SX1262 initialization:
 * Setup DIO2 to control the antenna switch
 * Setup DIO3 to control the TCXO power supply
 * Setup the SX1262 to use it's DCDC regulator and not the LDO
-* RAK4630 schematics show GPIO P1.07 connected to the antenna switch, but it should not be initialized, as DIO2 will do the control of the antenna switch
+* RAK4630 schematics show GPIO P1.07 connected to the antenna switch, but it should not be initialized, as DIO2 will do the
+control of the antenna switch
 
 SO GPIO 39/TXEN MAY NOT BE DEFINED FOR SUCCESSFUL OPERATION OF THE SX1262 - TG