Sweep up some missed trunk formatting

src/gps/GPS.cpp

@@ -811,12 +811,9 @@ void GPS::setPowerState(GPSPowerState newState, uint32_t sleepTime)
     LOG_INFO("GPS power state moving from %s to %s\n", getGPSPowerStateString(oldState), getGPSPowerStateString(newState));
 
 #ifdef HELTEC_MESH_NODE_T114
-    if( (oldState==GPS_OFF || oldState==GPS_HARDSLEEP) && (newState!=GPS_OFF && newState!=GPS_HARDSLEEP) )
+    if ((oldState == GPS_OFF || oldState == GPS_HARDSLEEP) && (newState != GPS_OFF && newState != GPS_HARDSLEEP)) {
-    {
         _serial_gps->begin(serialSpeeds[speedSelect]);
-    }
+    } else if ((newState == GPS_OFF || newState == GPS_HARDSLEEP) && (oldState != GPS_OFF && oldState != GPS_HARDSLEEP)) {
-    else if( (newState==GPS_OFF || newState==GPS_HARDSLEEP) && (oldState!=GPS_OFF && oldState!=GPS_HARDSLEEP) )
-    {
         _serial_gps->end();
     }
 #endif

src/graphics/Screen.cpp

@@ -1592,7 +1592,7 @@ void Screen::handleSetOn(bool on, FrameCallback einkScreensaver)
             dispdev->displayOn();
 #ifdef USE_ST7789
             pinMode(VTFT_CTRL, OUTPUT);
-            digitalWrite(VTFT_CTRL,LOW);
+            digitalWrite(VTFT_CTRL, LOW);
             ui->init();
 #ifdef ESP_PLATFORM
             analogWrite(VTFT_LEDA, BRIGHTNESS_DEFAULT);
@@ -1617,9 +1617,9 @@ void Screen::handleSetOn(bool on, FrameCallback einkScreensaver)
 #if defined(ARCH_ESP32)
             pinMode(VTFT_LEDA, ANALOG);
             pinMode(VTFT_CTRL, ANALOG);
-            pinMode(ST7789_RESET,ANALOG);
+            pinMode(ST7789_RESET, ANALOG);
-            pinMode(ST7789_RS,ANALOG);
+            pinMode(ST7789_RS, ANALOG);
-            pinMode(ST7789_NSS,ANALOG);
+            pinMode(ST7789_NSS, ANALOG);
 #else
             nrf_gpio_cfg_default(VTFT_LEDA);
             nrf_gpio_cfg_default(VTFT_CTRL);

src/main.cpp

@@ -320,12 +320,12 @@ void setup()
 #endif
 
 #ifdef SENSOR_POWER_CTRL_PIN
-    pinMode(SENSOR_POWER_CTRL_PIN,OUTPUT);
+    pinMode(SENSOR_POWER_CTRL_PIN, OUTPUT);
-    digitalWrite(SENSOR_POWER_CTRL_PIN,SENSOR_POWER_ON);
+    digitalWrite(SENSOR_POWER_CTRL_PIN, SENSOR_POWER_ON);
 #endif
 
 #ifdef SENSOR_GPS_CONFLICT
-    bool sensor_detected=false;
+    bool sensor_detected = false;
 #endif
 #ifdef PERIPHERAL_WARMUP_MS
     // Some peripherals may require additional time to stabilize after power is connected
@@ -467,7 +467,7 @@ void setup()
     } else {
         LOG_INFO("%i I2C devices found\n", i2cCount);
 #ifdef SENSOR_GPS_CONFLICT
-         sensor_detected=true;
+        sensor_detected = true;
 #endif
     }
 
@@ -715,20 +715,19 @@ void setup()
 #if !MESHTASTIC_EXCLUDE_GPS
     // If we're taking on the repeater role, ignore GPS
 #ifdef SENSOR_GPS_CONFLICT
-     if(sensor_detected==false)
+    if (sensor_detected == false) {
-     {
 #endif
-    if (HAS_GPS) {
+        if (HAS_GPS) {
-        if (config.device.role != meshtastic_Config_DeviceConfig_Role_REPEATER &&
+            if (config.device.role != meshtastic_Config_DeviceConfig_Role_REPEATER &&
-            config.position.gps_mode != meshtastic_Config_PositionConfig_GpsMode_NOT_PRESENT) {
+                config.position.gps_mode != meshtastic_Config_PositionConfig_GpsMode_NOT_PRESENT) {
-            gps = GPS::createGps();
+                gps = GPS::createGps();
-            if (gps) {
+                if (gps) {
-                gpsStatus->observe(&gps->newStatus);
+                    gpsStatus->observe(&gps->newStatus);
-            } else {
+                } else {
-                LOG_DEBUG("Running without GPS.\n");
+                    LOG_DEBUG("Running without GPS.\n");
+                }
             }
         }
-    }
 #ifdef SENSOR_GPS_CONFLICT
     }
 #endif

src/platform/esp32/main-esp32.cpp

@@ -229,7 +229,7 @@ void cpuDeepSleep(uint32_t msecToWake)
     // of just the first) gpio_pullup_en((gpio_num_t)BUTTON_PIN);
 
 #ifdef ESP32S3_WAKE_TYPE
-	esp_sleep_enable_ext1_wakeup(gpioMask, ESP32S3_WAKE_TYPE);
+    esp_sleep_enable_ext1_wakeup(gpioMask, ESP32S3_WAKE_TYPE);
 #else
 #if SOC_PM_SUPPORT_EXT_WAKEUP
 #ifdef CONFIG_IDF_TARGET_ESP32
@@ -240,7 +240,7 @@ void cpuDeepSleep(uint32_t msecToWake)
 #endif
 #endif
 
-#endif //#end ESP32S3_WAKE_TYPE
+#endif // #end ESP32S3_WAKE_TYPE
 #endif
 
     // We want RTC peripherals to stay on

src/platform/nrf52/NRF52Bluetooth.cpp

@@ -198,15 +198,13 @@ void NRF52Bluetooth::shutdown()
 {
     // Shutdown bluetooth for minimum power draw
     LOG_INFO("Disable NRF52 bluetooth\n");
-    uint8_t connection_num=Bluefruit.connected();
+    uint8_t connection_num = Bluefruit.connected();
-    if(connection_num)
+    if (connection_num) {
-    {
+        for (uint8_t i = 0; i < connection_num; i++) {
-        for(uint8_t i=0;i<connection_num;i++)
+            LOG_INFO("NRF52 bluetooth disconnecting handle %d\n", i);
-        {
-            LOG_INFO("NRF52 bluetooth disconnecting handle %d\n",i);
             Bluefruit.disconnect(i);
         }
-        delay(100);//wait for ondisconnect;
+        delay(100); // wait for ondisconnect;
     }
     Bluefruit.Advertising.stop();
 }

src/sleep.cpp

@@ -280,9 +280,9 @@ void doDeepSleep(uint32_t msecToWake, bool skipPreflight = false)
     }
 
 #if defined(I2C_SDA)
-		Wire.end();
+    Wire.end();
-		pinMode(I2C_SDA,ANALOG);
+    pinMode(I2C_SDA, ANALOG);
-		pinMode(I2C_SCL,ANALOG);
+    pinMode(I2C_SCL, ANALOG);
 #endif
 
 #endif

variants/heltec_capsule_sensor_v3/variant.h

@@ -45,7 +45,7 @@
 #define I2C_SCL 2
 #define HAS_SCREEN 0
 #define SENSOR_POWER_CTRL_PIN 21
-#define SENSOR_POWER_ON       1
+#define SENSOR_POWER_ON 1
 
 #define SENSOR_GPS_CONFLICT
 

variants/heltec_mesh_node_t114/variant.h

@@ -146,7 +146,7 @@ No longer populated on PCB
 
 #define GPS_L76K
 
-//#define PIN_GPS_RESET (32 + 6) // An output to reset L76K GPS. As per datasheet, low for > 100ms will reset the L76K
+// #define PIN_GPS_RESET (32 + 6) // An output to reset L76K GPS. As per datasheet, low for > 100ms will reset the L76K
 #define GPS_RESET_MODE LOW
 #define PIN_GPS_EN (21)
 #define GPS_EN_ACTIVE HIGH