* Fix type of nodeNum
Type of nodeNum is NodeNum, not uint
* typo
fixed typo "resumeAdverising()"
* fix missing #include "time.h"
Missing include breaks compilation with gccnoneeabi 12.3.1 for nrf52 targets on windows hosts.
* change type uint to unsigned int
uint is not a standard type. Using uint breaks compilation with gccnoneeabi 12.3.1 for nRF52 targets on windows hosts.
* fix type of channel_num
Type of channel_num should be uint32_t (as this is the type of hash() and numChannels).
Using uint non-standard type uint breaks compilation with gccnoneeabi 12.3.1 for nRF52 targets on windows hosts.
* Update nrf52.ini
Default build type should be "release" as this is the default of platformio.
* Update GPS.cpp
uint to unsigned int
* AdminModule: Publish fixed position updates
Enabled GPS thread when fixed position is updated, to let the GPS thread run once and publish the new fixed position.
Signed-off-by: Andrew Yong <me@ndoo.sg>
* GPS: Consider changes in only altitude as an updated point
Signed-off-by: Andrew Yong <me@ndoo.sg>
---------
Signed-off-by: Andrew Yong <me@ndoo.sg>
* Add better support for the Adafruit PiTFT 2.8 for Native
* native: Make touch i2c address configurable
* Bump portduino to pick up I2C features
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
* add new variant: TWC_mesh_v4
* fix trunk format
* fix format under wsl
* change board to TWC_mesh_v4
* change platformio & variant.h properly
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
The TW region had now power limit set, so defaulted to 16dBm.
The relevant regulation is section 5.8.1 of the Low-power Radio-frequency Devices Technical Regulations, which notes the limits of 0.5W (27dBM) indoor or coastal, 1.0W (30dBM) outdoor.
This patch updates the power limit to 27dbM, using the the lower limit specified in the regulations to be conservative.
Regulation references:
https://www.ncc.gov.tw/english/files/23070/102_5190_230703_1_doc_C.PDF (latest English version)
https://gazette.nat.gov.tw/egFront/e_detail.do?metaid=147283 (latest Chinese version, February 2024)
This enables the node and channel selection to be accessed by pressing the tab shortcut and then swiping between nodes or pressing tab again to change channels.
(To access the tab function look at my other pull request https://github.com/meshtastic/firmware/pull/3668)
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
