* Show ExternalNotification as excluded if it is
* Enable ExternalNotification, SerialModule and RangeTest on STM32WL
* Misc fixes for #7797 - ARCH_STM32 -> ARCH_STM32WL, use less flash by dropping weather station support for serialmodule, set tx/rx pins before begin
* Enable Serial1 on RAK3172, make SerialModule use it (console is on LPUART1)
* Fix SerialModule on RAK3172, fix board definition of RAK3172 to include the right pin mapping.
* protobufs
* initial mods, not tested
* manual telem packet creation, compiles.
* add gust and lull computation
* telem packet is getting fired off
* new pb ?
* pb and gust lull
* need to set the variant type for it to work.
* add gust and lull to mqtt json output.
* parse bat voltage and cap voltage and send the larger of the two in telem packet
also use the new ws85 serial mode (6). must set it with cli. : meshtastic --set serial.mode 6
* set hard coded average/transmit interval to 5 minutes.
* proper direction averging with trig.
* Update protobufs
* sweep some crud
* read in 512 bytes at a time and break and clear serial input if we got wind data
* factor out sendTelemetry function
* Revert "factor out sendTelemetry function"
This reverts commit b61ba1a3c5.
* Reapply "factor out sendTelemetry function"
This reverts commit d0af9cfd7d.
* update protobufs
* put WS85 Serial2 is tcho and canaryone exclusion #ifdef
* include GeoCoord.h so dr-dev will compile.
* remove old TODO comment.
* breakout WS85 serial operation to it's own function called processWXSerial()
* canaryone and t-echo exclusion for Serial2
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
* Support for SerialModule on RP2040
* Remove one !defined too many
* Increase serial RX_BUFFER: more reliable for long packets
Even results into an error for ESP32
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
