* When channel is active, first try receiving that packet
Afterwards we'll try transmitting again
* Remove setStandby in startSend
Already done in isChannelActive()
* Set LORA_DIO1 as RadioLib GPIO for SX127x
* LORA_DIO1 for Heltec v1, overlaps with GPS_TX
Set to RADIOLIB_NC for now
* If receive was not successful, startReceive doesn't trigger the interrupt
So we have to go back to transmitting anyway
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
The `RadioInterface::freq` member was encapsulated with the `RadioInterface::getFreq()` function,
which could be overridden in child classes for some LoRa-modules.
+#define MAX_POWER 27
// if we use 20 we are limited to 1% duty cycle or hw might overheat. For continuous operation set a limit of 17
+// In theory up to 27 dBm is possible, but the modules installed in most radios can cope with a max of 20. So BIG WARNING
+// if you set power to something higher than 17 or 20 you might fry your board.
Could cause hangs on the way into sleep (and enormous power consumption).
Instead of checking for rx packet length (which only changes at completion)
check if we've received preamble bits but haven't yet received a completed
packet interrupt.
notes:
wait to sleep loop problem
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
Can not send yet, busyRx
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
vs normal run
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
radio wait to sleep, txEmpty=0
Starting low level send (id=0x53fe1dd0 Fr0xe5 To0xff, WantAck0, HopLim3 encrypted)
Completed sending (id=0x53fe1dd0 Fr0xe5 To0xff, WantAck0, HopLim3 encrypted)
