Merge 66629ee242 into 44688e8363

As reported by @gruberaaron , work to improve the 1200bps reset for
esptool caused all runs of device-install.bat to use 1200bps as
the baud rate.

This change removes the general SET "ESPTOOL_BAUD=1200" that was causing
the issues and places the baud settings for reset mode inside the conditional.

Fixes https://github.com/meshtastic/firmware/issues/7172

bin/device-install.bat

@@ -100,7 +100,6 @@ IF NOT "!FILENAME:update=!"=="!FILENAME!" (
 )
 
 :skip-filename
-SET "ESPTOOL_BAUD=1200"
 
 CALL :LOG_MESSAGE DEBUG "Determine the correct esptool command to use..."
 IF NOT "__%PYTHON%__"=="____" (
@@ -142,7 +141,7 @@ CALL :LOG_MESSAGE INFO "Using esptool baud: !ESPTOOL_BAUD!."
 
 IF %BPS_RESET% EQU 1 (
     @REM Attempt to change mode via 1200bps Reset.
-    CALL :RUN_ESPTOOL !ESPTOOL_BAUD! --after no_reset read_flash_status
+    CALL :RUN_ESPTOOL 1200 --after no_reset read_flash_status
     GOTO eof
 )
 

src/mesh/RadioInterface.cpp

@@ -32,9 +32,10 @@ const RegionInfo regions[] = {
     RDEF(US, 902.0f, 928.0f, 100, 0, 30, true, false, false),
 
     /*
-        https://lora-alliance.org/wp-content/uploads/2020/11/lorawan_regional_parameters_v1.0.3reva_0.pdf
-     */
-    RDEF(EU_433, 433.0f, 434.0f, 10, 0, 12, true, false, false),
+        EN300220 ETSI V3.2.1 [Table B.1, Item H, p. 21]
+        https://www.etsi.org/deliver/etsi_en/300200_300299/30022002/03.02.01_60/en_30022002v030201p.pdf
+    */
+    RDEF(EU_433, 433.05f, 434.79f, 10, 0, 10, true, false, false),
 
     /*
        https://www.thethingsnetwork.org/docs/lorawan/duty-cycle/