#define BUTTON_PIN 9

#define HAS_SCREEN 0
#define HAS_GPS 0
#undef GPS_RX_PIN
#undef GPS_TX_PIN

#define USE_SX1262
#define LORA_SCK 10
#define LORA_MISO 6
#define LORA_MOSI 7
#define LORA_CS 8
#define LORA_DIO0 RADIOLIB_NC
#define LORA_RESET 5
#define LORA_DIO1 3
#define LORA_DIO2 RADIOLIB_NC
#define LORA_BUSY 4
#define SX126X_CS LORA_CS
#define SX126X_DIO1 LORA_DIO1
#define SX126X_BUSY LORA_BUSY
#define SX126X_RESET LORA_RESET
#define SX126X_DIO2_AS_RF_SWITCH
#define SX126X_DIO3_TCXO_VOLTAGE 1.8

// Vext_Ctrl pin controls 3.3V LDO (U2) which provides power to I2C peripheral
#define PIN_POWER_EN 1

// Board has I2C connected to UART0 pins, and no other hardware serial port
#define UART_TX -1
#define UART_RX -1

// Board has I2C connected to U0RXD and U0TXD
#define I2C_SDA 21
#define I2C_SCL 20

// Board has RGB LED on GPIO2
#define HAS_NEOPIXEL                         // Enable the use of neopixels
#define NEOPIXEL_COUNT 1                     // How many neopixels are connected
#define NEOPIXEL_DATA 2                      // gpio pin used to send data to the neopixels
#define NEOPIXEL_TYPE (NEO_GRB + NEO_KHZ800) // type of neopixels in use