mirror of
https://github.com/meshtastic/firmware.git
synced 2025-02-02 18:59:56 +00:00
b59368ca3c
* Added the last mac address bytes in bluetooth device name ESP32Bluetooth.cpp Add default notification pinout to tlora_v2_1_16/variant.h * updated ADC_MULTIPLIER value for more accuracy * Update variant.h Updated LORA_RESET GPIO in this board is 23 Removed LORA_DIO1 35 , gpio 35 is a battery pin Removed LORA_DIO2 34, gpio 34 is unuse in this board Co-authored-by: Ben Meadors <benmmeadors@gmail.com> Co-authored-by: Thomas Göttgens <tgoettgens@gmail.com>
27 lines
1014 B
C
27 lines
1014 B
C
#undef GPS_RX_PIN
|
|
#undef GPS_TX_PIN
|
|
#define GPS_RX_PIN 15 // per @der_bear on the forum, 36 is incorrect for this board type and 15 is a better pick
|
|
#define GPS_TX_PIN 13
|
|
|
|
#define EXT_NOTIFY_OUT 2 // Default pin to use for Ext Notify Module.
|
|
|
|
#define BATTERY_PIN 35 // A battery voltage measurement pin, voltage divider connected here to measure battery voltage
|
|
// ratio of voltage divider = 2.0 (R42=100k, R43=100k)
|
|
#define ADC_MULTIPLIER 2.11 // 2.0 + 10% for correction of display undervoltage.
|
|
|
|
#define I2C_SDA 21 // I2C pins for this board
|
|
#define I2C_SCL 22
|
|
|
|
#define RESET_OLED 16 // If defined, this pin will be used to reset the display controller
|
|
|
|
#define VEXT_ENABLE 21 // active low, powers the oled display and the lora antenna boost
|
|
#define LED_PIN 25 // If defined we will blink this LED
|
|
#define BUTTON_PIN 12 // If defined, this will be used for user button presses,
|
|
|
|
#define BUTTON_NEED_PULLUP
|
|
|
|
#define USE_RF95
|
|
#define LORA_DIO0 26 // a No connect on the SX1262 module
|
|
#define LORA_RESET 23
|
|
|