mirror of
https://github.com/meshtastic/firmware.git
synced 2025-02-01 18:29:56 +00:00
8b82ae6fe3
* Use UINT32_MAX to indicate no configured GPS * Refactor GPS to not probe if pins not defined * Minor cleanups related to rework * Use Named Constructor to clean up code * Actually disable the GPS thread * Don't actually disable the GPS thread * Move doGPSPowerSave to GPS class * Make sure to set GPS awake on triple-click --------- Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
36 lines
1.1 KiB
C
36 lines
1.1 KiB
C
#define LED_PIN LED
|
|
|
|
#define RESET_OLED RST_OLED
|
|
#define I2C_SDA SDA_OLED // I2C pins for this board
|
|
#define I2C_SCL SCL_OLED
|
|
|
|
// Enable secondary bus for external periherals
|
|
#define I2C_SDA1 SDA
|
|
#define I2C_SCL1 SCL
|
|
|
|
#define VEXT_ENABLE Vext // active low, powers the oled display and the lora antenna boost
|
|
#define BUTTON_PIN 0
|
|
|
|
#define BATTERY_PIN 1 // A battery voltage measurement pin, voltage divider connected here to measure battery voltage
|
|
#define ADC_CHANNEL ADC1_GPIO1_CHANNEL
|
|
#define ADC_ATTENUATION ADC_ATTEN_DB_2_5 // lower dB for high resistance voltage divider
|
|
#define ADC_MULTIPLIER 4.9
|
|
|
|
#define USE_SX1262
|
|
|
|
#define LORA_DIO0 -1 // a No connect on the SX1262 module
|
|
#define LORA_RESET 12
|
|
#define LORA_DIO1 14 // SX1262 IRQ
|
|
#define LORA_DIO2 13 // SX1262 BUSY
|
|
#define LORA_DIO3 // Not connected on PCB, but internally on the TTGO SX1262, if DIO3 is high the TXCO is enabled
|
|
|
|
#define RF95_SCK 9
|
|
#define RF95_MISO 11
|
|
#define RF95_MOSI 10
|
|
#define RF95_NSS 8
|
|
|
|
#define SX126X_CS RF95_NSS
|
|
#define SX126X_DIO1 LORA_DIO1
|
|
#define SX126X_BUSY LORA_DIO2
|
|
#define SX126X_RESET LORA_RESET
|
|
#define SX126X_E22 |