firmware/TODO.md

High priority

• make message send from android go to service, then to mesh radio
• make message receive from radio go through to android
• have MeshService keep a node DB by sniffing user messages
• have meshservice send location data on mesh (if device has a GPS)

Medium priority

• correctly map nodeids to nodenums, currently we just do a proof of concept by always doing a broadcast

• add interrupt detach/sleep mode config to lora radio so we can enable deepsleep without panicing

• figure out if we can use PA_BOOST

• scrub default radio config settings for bandwidth/range/speed

• use a freertos thread to remain blocked reading from recvfromAckTimeout, so that we don't need to keep polling it from our main thread

• override peekAtMessage so we can see any messages that pass through our node (even if not broadcast)? would that be useful?

• sendToMesh can currently block for a long time, instead have it just queue a packet for a radio freertos thread

• fix the logo

Pre-beta priority

• make sure main cpu is not woken for packets with bad crc or not addressed to this node - do that in the radio hw
• enable fast init inside the gps chip
• dynamically select node nums
• triple check fcc compliance
• allow setting full radio params from android

Low priority

• report esp32 device code bugs back to the mothership via android

Done

• change the partition table to take advantage of the 4MB flash on the wroom: http://docs.platformio.org/en/latest/platforms/espressif32.html#partition-tables
• wrap in nice MeshRadio class
• add mesh send & rx