1.8 KiB
RAK Wireless RisBlock
Docs
https://docs.rakwireless.com/Product-Categories/WisBlock/Quickstart/#wisblock-base-2
GPS module: Supposedly "Install in slot A only" but I think installing on the back would fit better with the OLED. FIXME. https://docs.rakwireless.com/Product-Categories/WisBlock/RAK1910/Overview/#product-description
ST KPS22HB baro sensor https://docs.rakwireless.com/Product-Categories/WisBlock/RAK1902/Overview/#product-description
OLED https://docs.rakwireless.com/Product-Categories/WisBlock/RAK1921/Overview/#product-features Must be installed on the front for the I2C wires to lineup
Solar enclosure https://docs.rakwireless.com/Product-Categories/Accessories/RAKBox-B2/Overview/#product-description
Base datasheet (for GPIO mapping) https://docs.rakwireless.com/Product-Categories/WisBlock/RAK5005-O/Datasheet/#specifications
CPU module carrier (rak4631) https://docs.rakwireless.com/Product-Categories/WisBlock/RAK4631/Datasheet/#specifications
TODO
3V3_S is another 3.3 V power supply, it can be controlled by the MCU in order to disconnect the power sensors during idle periods to save power. 3V3_S is controlled by IO2 pin on the WisBlock Core board. Set IO2=1, 3V3_S is on. Set IO2=0, 3V3_S is off.
- DONE solder header
- DONE attach antenna
- get building (LORA disabled)
- DONE FIX LEDs
- DONE FIX BUTTONs
- DONE FIX I2C assignment
- FIX LORA SPI
- FIX GPS GPIO assignment
- Disable Bluetooth
- Disable LORA
- Boot
- Enable LORA but no TX
- Enable LORA TX
- Enable bluetooth
- Relase as standard part of build (including UF2s)
- Make this doc into a nice HOWTO: what to order, how to connect (which device in which slots), how to install software
- Setup battery voltage sensing
- Set bluetooth PIN support
- Confirm low power draw
- send in PR to https://github.com/geeksville/WisBlock for boards define